AESWave - Phil's Electrical Piercing Probe

Phil Fournier, NAPA Tech of the Year, and now Probe Master!

This probe ends the frustration encountered with previous piercing probes. Designed and tested by a techncian for technicians.

* Long reach = 11-inches
* Pierces wires from 10 to 18 gauge
* Banana socket connection or use an alligator clip right on the shaft just below the handle
* 5 piercing pins ensure good connection
* One-handed operation

What's NEW about Phil's Piercing Probe
1- The shaft is constructed of a thicker wall. Earlier versions used thinner material that tended to crack and break
2- The tip is a little bigger than before. Even though the tip tapers to a point it is takes a steady hand to separate wires that are tightly packed together.

NOTES:
To keep you probe working over the long hual we suggest you do the following:
1- When this probe is piercing a wire you should support its weight and do not let it hang. The long probe will act as a lever which puts excess force on the needles and delicate tip possibly damaging the probe. We suggest you securely anchor the probe to some stationary object with masking tape, rubber band, etc.
2- This probe is spring loaded and pierces the wire on it's own. Trying to force the needles into a wire could damage the probe.
3- Do not drop it.
4- Do not let anyone else use it! Borrowers can be abusers!

Warning!
The Phil's Probe is designed to be used only on low voltage DC circuits such as the 12 volt DC automotive system circuits. DO NOT use on house or building type high voltage A/C (alternating current) circuits as an extreme shock hazard is present.